Arduino Uno Rev3

499.00

Description

This Arduino Uno is an original microcontroller board from Arduino officials based on the ATmega328P.  It has 14 digital input/output pins (of which 6 can be used as PWM outputs), 6 analog inputs, a 16 MHz quartz crystal, a USB connection, a power jack, an ICSP header and a reset button. It contains everything needed to support the microcontroller; simply connect it to a computer with a USB cable or power it with an AC-to-DC adapter or battery to get started.. You can tinker with your UNO without worrying too much about doing something wrong, worst case scenario you can replace the chip for a few dollars and start over again.

“Uno” means one in Italian and was chosen to mark the release of Arduino Software (IDE) 1.0. The Uno board and version 1.0 of Arduino Software (IDE) were the reference versions of Arduino, now evolved to newer releases. The Original Arduino Uno Rev3 board is the first in a series of USB Arduino boards and the reference model for the Arduino platform; for an extensive list of current, past or outdated boards see the Arduino index of boards.

 

Model Type Arduino Uno R3
Microcontroller Chip ATmega328P
Operating Voltage 5 V
Input Voltage(Recommended) 7-12V
Analog I/O Pins 6
Digital I/O Pins 14 (of which 6 provide PWM output)
PWM Digital I/O Pins 6
Clock Speed 16 MHz
Flash Memory 32 KB (ATmega328P) of which 0.5 KB used by bootloader
SRAM 2 KB (ATmega328P)
EEPROM 1 KB (ATmega328P)
DC Current for 3.3V Pin 50 mA
DC Current per I/O Pin 20 mA
On Board LEDs Yes
Operating Temperature (°C) -10 to 60

Reviews

There are no reviews yet.

Be the first to review “Arduino Uno Rev3”

Your email address will not be published. Required fields are marked *